Siemens SITRANS FUH1010PVDX, Operating Instructions Manual, Page: 179 / 308

5-77
CQO:1010PVXFM-3 Section 5
Date
The [Date] command sets the month, day and year for the meter’s internal clock/calendar. Enter the date
using the [MM.DD.YY] format. Replace MM with two digits to indicate the month. Replace DD with two
digits to indicate the day. Replace YY with two digits to indicate the year. Type the period (.) separator
between each set of digits. For example, you would enter December 7, 1997 by typing 12.07.97. You
can use the <Right Arrow> to move the cursor back to a number if you need to re-type it. Press the
<CLR> key to remove the current setting.
To set the Date:
To enable numeric entry press
Use PC numeric keys or Magnetic Wand to enter the date (MM.DD.YY).
To store the date press . This moves the cursor to [Time].
Time
The [Time] command sets the hours and minutes for the meter’s internal clock/calendar. Enter the time
using the [HH.MM.SS] format. Replace HH with 2 digits to indicate the hour (use 24-hr. clock format).
Replace MM with 2 digits to indicate the minutes. Replace SS to indicate the seconds. You also have to
type the period (.) separator between each set of digits. For example, you would enter ten minutes after
two o’clock in the afternoon by typing: 14.10.00 You can use the <Right Arrow> to move the cursor back
to a number if you need to re-type it. Press the <CLR> key to remove the current setting.
To set the clock:
To enable numeric entry press
Use PC numeric keys or Magnetic Wand to enter the time (HH.MM).
To store the time press . This moves the cursor to [RS-232 Setup] menu cell.
5.10.9 RS-232 SETUP
Use the [RS-232 Setup] menu cell to set the operating parameters of the serial I/O port. Settings include
baud rate, parity, data bits, line feed, network ID number and waiting period before a RTS time-out. Only
activate the RS-232 output if you intend to transmit serial data. This will avoid burdening the system with
unnecessary data transferals while it is performing flow computations.
NOTE: The RS-232 stop bit implementation is fixed. If you are using a communication program
such as Windows 3.xx Terminal or Windows 95/98/NT/2000/XP HyperTerminal, that in-
cludes a field for stop bits, select 1 stop bit.
ENT
ENT