Siemens SITRANS FUH1010PVDX, Operating Instructions Manual, Page: 40 / 308

2-2
CQO:1010PVXFM-3
Section 2
2.2 .2 POWER SUPPLY WIRING
z
Using a 1/16" Hex key, loosen the Rear Housing Cover locking setscrew.
z
Unscrew the Rear Housing Cover and remove.
z
Locate power supply connector J8. Use the tables below and the part number of your unit to determine
the correct input power source. (See ID label on right side of housing.)
Input Power Connector (P8) Wiring
z
Pull the desired length of input power wires through Flow Display Computer case conduit cable hole
and into flowmeter case before wiring connector.
z
Wire input power connector P8 for AC or DC power depending on power supply provided as shown
below. Insert wires into wire entry holes and secure by tightening wire clamp screws (see figure
below). NOTE: Power Supply connector wires should be stripped AWG 12 -18 stranded or
solid conductors.
1 Hot Positive Positive (Gnd)
2 Neutral Negative (Gnd) Negative
3 Ground Ground Ground
Terminal 1010X-6SS2 1010X-6ZNS2 1010X-6ZPS2
Number
Root Meter Number
Transducer Support
Relay Support
Numeric Display
Power Supply Option
1010X-T2KNZPL2-S2----Safety Rating Option
Language Option
Typical Part Number Construction:
NOTE: Power Supply Module P/N label is located inside the front housing cover.
Power Supply Option Code Power Supply P/N User Supplied Power
S 1010X-6SS2 90-250 VAC Single Phase
ZN 1010X-6ZNS2 9-36 VDC Negative Ground
ZP 1010X-6ZPS2 9-36 VDC Positive Ground
NOTE: Loosen Wire Clamp
Screw, insert stripped end
of wire and then retighten.
GND
GND
3
2
1
HOT
+
DC
AC
P8
NEU
-
2
3
1
Connector
Mounting
Screws
Stripped Wire
Wire
Clamp
Screws
Hot Neu GND
Color Codes
USA BK WH GRN
EU BR BL Y/GRN
NOTE: The input power connector consists of a removable wire plug and PCB header located on the
1010X-8 I/O module. Two screws secure the wire plug to the header. The connector assembly is fully
polarized for fast and easy mating. The wire plug accepts stranded or solid conductors of AWG 12 - 18.