Siemens 6EP4131-0GB00-0AY0, Equipment Manual

Page: 182 / 264

Troubleshooting
SITOP UPS1600 / BAT1600 / UPS1100
182
Equipment Manual, 07.2021, A5E37775406-11-76
Error
Type
Ex-
tend-
ed
Error
Type
Severity Alarm Text Help Text
256 22 MR Wrong device ID An attempt was made to update the software with an update
file that is not suitable for the UPS1600.
256 23 MR Corrupt data record Error during software update - try to update the software again
256 24 MR Wrong update An attempt was made to update the software with an invalid
update file. The update file is probably too old.
256 25 MR Too much data An entry in the software update cannot contain more than
32 bytes of reference data.
256 26 F Device failure Device failure
256 27 F No boot loader available No boot loader available
257 1 MD Buffer mode is not possible Buffer mode not possible - check cabling, fuse and battery
voltages
257 2 MR Device temperature critical
(too high)
Device temperature higher than 100 °C. Caution: The highest
permitted temperature could be exceeded!
257 3 MR Device temperature critical
(too low)
Device temperature less than -10 °C. Device could leave the
operating range.
257 4 MR High-resistance connection
to battery
High-resistance connection to battery - check battery power
cable
257 5 MD Power supply to at least one
battery interrupted
Connection to battery interrupted - check connection and fuse
257 6 MR Unknown battery Data from the battery cannot be read correctly. Battery is defec-
tive or not supported by SIEMENS.
257 7 MD Overcurrent Output current of UPS1600 is too high. Output is switched off
for 20 s. The output is switched on again after 20 s.
257 8 N Reset buffer timer PC is shutting down
257 9 N UPS1600 off UPS1600 off - buffer time exceeded.
257 10 MR Output switched off The UPS1600 output was shut down as result of executing an
instruction or an error situation (e.g. overtemperature, exces-
sive output current).
257 11 N Output switched on
obsolete from V2.3
The UPS1600 output was switched on again as result of execut-
ing an instruction or the correction of an error situation.
257 12 N Reset executed Input voltage at UPS1600 was OK again before the buffer time
expired. Connected devices are reset by switching off the
UPS1600 outputs for the configured time.
257 13 MD Battery test is negative A cyclic battery test will be performed
Remark:
For firmware versions from V2.2 - and for versions V2.0.× from
version V2.0.5, the alarm is deactivated.
257 14 N Software update successful Previous software update was successful - UPS1600 is opera-
tional again.
257 15 MD Input voltage is too high Input voltage exceeds 30 V. UPS1600 is not operational.
257 16 MR Surplus battery More than 6 batteries are connected. Connect max. of
6 batteries to the Energy Storage Link.
257 17 F UPS1600 parameters cor-
rupt
UPS1600-parameters corrupt - try to update the software.
257 18 F Device overtemperature Output and battery charging is switched off to prevent damage
to the device.
257 19 MR Capacity test Capacity test being performed