Siemens 6EP4131-0GB00-0AY0, Equipment Manual

Page: 134 / 264

Engineering and remote access
3.9 Web server
SITOP UPS1600 / BAT1600 / UPS1100
134
Equipment Manual, 07.2021, A5E37775406-11-76
Grayed out menus
If the SITOP UPS1600 was assigned a SIMATIC S7 control as I/O device, or the SITOP Manager
is connected to the SITOP UPS1600, then the web server is in the read-only mode. The
following applies in the read-only mode:
•
Write access not possible, the parameter settings can only be read (input values shown in
gray, valid for software version up to V2.0).
3.9.3 Functions of the web server
The functions of the web server are split up between the two menus "Diagnostics" and "HW
Configuration".
Use the "Download to device" function to load changes that you have made to the device, see
Load / Save (Page 155).
Diagnostics
You can find the following submenus here:
•
Alarms:
For an overview of past and active alarms, see Alarm monitoring (Page 136).
• Operating data:
For an overview of the operating data, see View the data of the SITOP UPS1600 (basic
device) (Page 137) and Viewing the energy storage data (Page 138)
• Online functions with the options:
– Output ON/OFF
– Firmware update
– Reset to factory setting
For the online functions, see Online functions (Page 140).
HW configuration
Here, in the following areas you can make changes:
•
Enter identification data on the device and location of use
• Configuring the communication interface, see General (Page 142)
• Changing the web server settings, see Web server (Page 144)
• Configuring the OPC UA interface, see OPC UA server (Page 145)
• NTP Configuring time synchronization
• Making PN security settings, see PROFINET security (Page 147).
• User management, see User administration (Page 147)
• Configuring basic units and energy storage devices, see Device configuration (Page 149)