8. Commissioning
Original Operating Manual | Edition 1.0 (01-2020) | CrimpCenter 64 SP
163 | 268
8.7.12
Adjust the Contact Pressure of the Wire Feed
Fig. 78: Wire feeding unit - Contact pressure
The pressure regulator is located under the
wire feeding unit.
Here the contact pressure can be read.
You can set the desired pressure in the EASY software.
The following steps will show you how to do this.
1.
▹
Switch to the tab Wire Feeding Unit.
(The following pages will tell you how to get there.)
2.
▹
Enter the desired pressure there.
3.
▹
Apply the value.
The set pressure is saved with the order data.
The pressure is automatically adjusted on load of the order.
The pressure of the active order will be applied.
EASY - Settings
Tab - Wire feeding unit
Press the following button:
Press the following button:
In this tab you can make the following settings.
Picture / Screen text
Translation
Description
Speed
Speed
Here you can set the speed of the wire
feeding unit.
Acceleration
Acceleration
Here you can set the acceleration when
starting up the wire feeding unit.
Deceleration
Deceleration
Here you can set the deceleration when
running down the wire feeding unit.