8. Commissioning
150 | 268
Original Operating Manual | Edition 1.0 (01-2020) | CrimpCenter 64 SP
8.7.7
Use Dual ToolingShuttle
With the Dual ToolingShuttle it is possible to switch between two material feeders in a very
short time. The material and applicator not included in the current production can be direct-
ly loaded at the CrimpCenter.
With 5 simple steps, the change is made.
1.
▹
Loosen
2.
▹
Swing out
3.
▹
Rotate
4.
▹
Swing in
5.
▹
Snap in
Notice
In order to mark the different sides, parts of the material rolls orange and gray were dyed.
Fig. 58: Dual ToolingShuttle - Gray - Engaged Fig. 59: Dual ToolingShuttle - control ele-
ment
Fig. 60: Dual ToolingShuttle - Gray - middle
position
Fig. 61: Dual ToolingShuttle - gray - end posi-
tion