Sako SKI600, Manual

Page: 145 / 180

139
The items of main monitoring interface can
be changed by modifying the set value of
the above function codes. For example: set
PE.08=5, then output current d-05 is selected,
and the monitoring interface will display
the present output current as default during
operation.
FE.08
Monitoring parameters selection 1 in
operation status
0 ～ 57
0
FE.09
Monitoring parameters selection 2 in
operation status
0 ～ 57
5
The items of main monitoring interface can
be changed by modifying the set value of
the above function codes. For example: set
FE.10=5, then output current d-06 is selected,
and the monitoring interface will display the
present output voltage as default during stop
status.
FE.10
Monitoring parameters selection 1 in
stop status
0 ～ 57
1
FE.11
Monitoring parameters selection 2 in
stop status
0 ～ 57
12
0: disabled
The driver is in normal read and write status.
Whether the setting value of function codes
can be modified is relevant to the setting
of user password and present operation
status.
1: restore to factory defaults (all user
parameters except motor parameters)
A l l u s e r pa ra m ete r s e xce pt m oto r
parameters will be restored to factory
defaults.
2: restore to factory defaults (all user
parameters)
All user parameters will be restored to
factory defaults.
3: clear fault record
C l ea r t h e co n te n ts o f fa u l t re co rd
D-48 ～ D-57. After this operation, this
function code will clear to 0 automatically.
FE.13
Parameter initialization
0 ～ 3
0
LED one's place: function parameters display
mode
0: display all function parameters
1: only display parameters different from
default value.
FE.12
Parameter display mode
00 ～ 11
0000
4.2 Detailed Function Description
2: only display parameters modified after
power on of the last time (reserved).
LED ten's place: monitoring parameters
display mode
0: only display main monitoring parameters
1: alternate display of main and auxiliary
parameters (interval time 1s)
LED hundred's place and thousand's place:
reserved