Sako SKI600, Manual

Page: 144 / 180

138
FE.00
LCD language option (LCD)
0 ～ 2
0
0: Chinese 1: English 2: reserved
FE Panel Function Setting and Parameter
Management (PD group reserved)
FE.01
Key M-FUNC function
0 ～ 4
0
0: JOG (jog control)
key is for jog control, and the
default direction is set by F0.21.
1: FWD/REV switch
equals direction switch key in
running status, and is disabled in stop
status. this switching is only effective to
command giving method of keypad.
2: clear frequency set by .
M-FUNC
M-FUNC
▲ / ▼
4.2 Detailed Function Description
FE.02
Key STOP/RST function
0 ～ 3
3
0: only effective to panel control
Only when F0.06=0, this key can control the
driver to stop.
1: effective to both panel and terminal control
Only when F0.06=0 0r 1, can this key control
the driver to stop.In the communication
control mode, this key is invalid.
2: effective to both panel and communication
control
Only when F0.06=0 0r 2, can this key control
the driver to stop.In terminal control mode,
this key is invalid.
3: effective to all control modes
This key can control the driver to stop in all
control modes.
Notice :
In all command giving methods, reset function is
enabled.
This function code is used to calibrate
the error between the actual parameters
(pressure, flow rate, etc.) and preset or
feedback parameters (voltage, current). It has
no effect on close-loop regulation.
FE.04
Close-Ioop display factor
0.01 ～ 100.00
1.00
0: disabled
1: coast to stop
Press and , the driver will
coast to stop.
RUN STOP/RESET
FE.03
STOP + RUN emergency stop
0 ～ 1
1
FE.07
Encoder regulation speed
1 ～ 100
70
This function is used to calibrate the error
of line speed display. It has no effect on the
actual speed.
FE.06
Line speed factor
0.01 ～ 100.00
1.00
This function code is used to calibrate the
error of rotating speed display. It has no effect
on the actual speed.
FE.05
Rotating speed display factor
0.01 ～ 100.00
1.00