Reinke Ontrac, Installation And Service Manual

Page: 81 / 207

7
Options: Pressure Switch (350730)
P/N 110561
P/N 140730
P/N 45019
P/N 8106
P/N 57083
P/N 112958
P/N 57080
P/N 113136
140730
350730
Installation for 350730 will include: Pressure Switch Sub-Assembly (P/N 140730), 8’ of tubing-1/4” nylon
heavywall (P/N 45019), Male Connector 1/4” barb x 1/8” NPT (P/N 8106)
P/N 140730 consists of: #22 Black Wire (P/N 57080), #22 White Wire (P/N 57083), Pressure Switch
(P/N 112958), 2-Reducing Washers (P/N 110561), Locknut-1/2” Electric Connector (P/N 113136)
Verify that all parts match accordingly.
350730 - (Ontrac Pressure Switch) - This option provides the wet/dry status of the system.
!
!
Begin Installation:
1. Disconnect the battery cable from the RTU board.
2. Install the pressure switch in a 7/8” hole in tower box or post unit.
3. Install one conn-male 1/4 barb x 1/8” NPT in the pressure switch and one in the water pipe.
4. Join the two conn-male with the nylon tubing.
5. To wire the pressure switch connect NC and common contacts to the white and black terminal on input 3
(Note: it doesn’t matter which wire goes where).
6. Hareware install is complete.
7. If installing on an existing unit proceed to the next step, (if not go back to installation instructions for the
Ontrac that is being installed.
8. BEFORE LEAVING THE FIELD, COMPLETE VERIFICATION PROCEDURE BELOW
VERIFICATION:
1. Check digital input 3, see if the white terminal reads 5 VDC when the water is applied to the system and
0 VDC if the water is off.
2. Use internet access e.com/field_test and radio number to verify communication http://admin.ontracbyreink
and input status.
3. Compare the raw number status to the input voltage (keeping in mind 5 VDC is on and 0 VDC is off)
4. If Installing on an existing unit call Reintech at 1-888-872-2360 to complete setup.
5. If questions or concerns arise contact technical support.
6. Verification is complete.
Ontrac Installation Manual
Before attempting any service or installation work ensure the Disconnect Switch
on the Main Control Panel is . OFF