Reinke Ontrac, Installation And Service Manual

Page: 69 / 207

Ontrac Installation Manual
4
Ontrac Cell Base Install (350785) & Mounting (355735)(351531)
1. After all options are installed and wiring is complete connect the battery to the battery terminal
a. This will initiate the G2 board and cell modem to boot.
b. This can also be done by using any of the three types of DC inputs: Battery, Solar 1 and 2,
or Power Supply
c. You will see the following via the LCD: Start Boot, Initializing.., Startup Comms: Modem
A Waiting…, Connection Made, Xmit OK: Success (means a boot report was successfully
sent)
Note: These screen displays happen fairly fast. If GPS is enabled on G2 board boot it will
be noted on the LCD between Initializing and starting Comms.
d. The Red LED on Modem should flash at a consistent rhythm about every 2 seconds.
Note: A rate of about 1/2-1 second indicates the radio is online with the cell
network and is sending or receiving information.
2. About two minutes after a successful boot the unit will send a station report. This will give the
status of all its monitoring parameters.
3. Use the customer user interface to verify the system reports the system running forward and
reverse.
website (user interface) http://www.ontracbyreinke.com
OR
4. Use http://admin.ontracbyreinke.com/field_test website and radio number.
Verify orbcomm status = 13 when running forward and 5 when running reverse.
Note: Step 4 is only necessary if the raw data is needed to verify correct unit operation
or you do not have access to step 3. For additional information see Cell Tab in
Remote Control and Monitoring Manual P/N 117804 from Reinke Service School.
1. Record the radio number for each unit, customer and system name in your dealerships data base for
future identification.
2. The radio number will be required when contacting technical support for trouble shooting.
3. Verification is complete for this installation.
4. Complete the verification process for each additional option installed, using the appropriate
instruction sheet for that option.
Verification
Records
Two Options Available to Verify Communication & Input Status