Reinke Ontrac, Installation And Service Manual

Page: 123 / 207

20
Ontrac Installation Manual
Cell Option: Rain Gauge (350741)
350741 - (Ontrac Cell-Rain Gauge) -
Rain gauge will allow end user to monitor rainfall.
Verify that all parts match accordingly.
140741 Rain Gauge Assy - Ontrac G2
1. Verify the battery, solar and any other power supply is disconnected from the G2 Board. If not disconnect
them from the board.
2. Install the strain relief in the Ontrac Tower box base. There are two knockouts provided in the tower box
base they are located next to:
a. The antenna cable strain relief
b. The isolation relay
Otherwise drill out a 7/8” hole for the strain relief.
3. Tighten the lock nut to secure the strain relief.
4. Install the rain gauge using two screws and nut onto the antenna bracket, then tighten them down. (Fig 1.)
5. Route the rain gauge wire cable through the strain relief and into the Ontrac tower box and wire per print on
next page. (Fig 1.)
6. Installation is complete.
7. Complete all other options installations prior to completing the Verification steps on the next page.
Step 4
Fig 1.
Set-Up
Installation
!
!
Before attempting any service or installation work ensure the Disconnect Switch on the Main
Control Panel is
. Read all installation instructions and options to be installed before OFF
beginning installation.
1. If this is a retro installation call Dealer Support at (800)947-4868 to complete setup.