Reinke Ontrac, Installation And Service Manual

Page: 13 / 207

Ontrac Kit - Post Tower Mount - Iridium (350782)
Step 4: Install sheet metal plate.
Turn off B Tower Box disconnect
and install 1 1/4” X 2 ½” (P/N
146721) sheet metal plate with #8
screws (P/N 3002) in B Tower
Box. Connect power supply using
the magnet to the plate. (See
figure 1)
Step 5: Wiring the 12 VDC power supply (P/N 147052).
(See Figure 1)
a. Connect orange wire from power supply to constant 120 VAC when pivot is running in either
direction.
b. Connect white wire to neutral
c. Connect Green wire to ground
(See Figure 2)
d. Bring in the gray wire harness with strain relief from Ontrac unit into the B Tower Box
e. Connect red wire from wire harness to V+ on power supply
f. Connect Black wire from wire harness to V- on power supply
g. Connect Green wire from wire harness to ground on power supply
h. Connect shield wire from wiring harness to earth ground(not pictured)
a.
b.
c.
d.
g.
e.
f.
d.
Figure 1
Figure 2
Ontrac Installation Manual
Sheet metal plate
top view of power supply
86