Reinke Ontrac, Installation And Service Manual

Page: 43 / 207

Ontrac Installation Manual
116
Ontrac Tower Mount With Stop & GPS-Iridium (350784GPS)
Step 14.
Connect Tower Box “B” to Ontrac Box. A 7 Conductor Cable will connect the Tower and Ontrac
Boxes. Use the supplied seven conductor cable and strain relief connectors. The Ontrac Stop Relay is
wired in series with the pivot safety circuit. When the stop command is received by Ontrac, the safety
circuit is opened for eight seconds to stop the pivot.
The Ontrac to Tower Box Cable functions are:
Green: Ground - Attach to the Tower Box ground lug
White: Neutral - Attach to the Tower Box neutral
Purple: Forward - Attach to the Tower Box forward AC control wire
Pink: Reverse - Attach to the Tower Box reverse AC control wire
Brown: Limit in - Wire in series with the limit circuit
Yellow: Limit out - Wire in series with the limit circuit
See Options Tab for installion any options on this unit (if no options exist go to next step)
Before attempting any service or installation work ensure the Disconnect Switch on the Main
Control Panel is OFF. Also make sure the “B” Box is OFF before installing this option. Read
all installation instruction and options to be installed before beginning installation.
!
!
Step 15. Connect the Battery. Attach the Spade
Connectors of the Battery Cable to the corresponding
Red and Black Terminals on the Battery. Attach the 6-
Position Battery Cable to the 4-Pin BATT Connector on
the Ontrac RTU Board. Use care to match the middle
four holes in the Connector to the four Terminal Pins.
Connecting the Battery will activate the Ontrac Unit.
The red SV LED will blink once, immediately followed
by a series of three blinks. The Ontrac Unit will warm
up for two minutes before fully activating and sending
the first report.
6-Position Battery Cable
connect to the
4-Pin Connector
of
Ontrac Board
“SV” LED Light
Location
“GPS” 4 Pin
Connector