Reinke Ontrac, Installation And Service Manual

Page: 54 / 207

7
Satellite Plus w/RAMS (350778)
Ontrac Installation Manual
!
Before attempting any service or installation work ensure the Disconnect Switch on the Main
Control Panel is
. Read all installation instructions and options to be installed before
OFF
beginning installation.
Step 3:
Install the Rail-Terminal Block 8-7/8” (P/N
122660) to the backplate as shown, using 2 Screws
#8-32 x 3/8” Pan Head Type 23 (P/N 3003) and 2
Washers 3/16 Flat USS ZC (P/N 1501). (Left of the
transformer) **Preferred Location
Step 4: Install the Satellite Plus w/RAMS Assembly
(P/N 140779) to the Rail as shown.
Step 5: Install the Battery Holder (P/N 110548) and 2
Screws #8-32 x 3/8” Pan Head Type 23 (P/N 3003) as
shown.
Note:
If this location is taken it can be
mounted on the inner door using the two
studs closet to the hinge side of the
door.
Caution should be taken mount
do not
on the middle and outer studs as this will
cause interference with the closing of the
inner door.
!
Step 6:
Install the Battery (P/N 116900-3).