Reinke Ontrac, Installation And Service Manual

Page: 105 / 207

Ontrac Installation Manual
2
Cell Option: Basic Control Board (350774)
Installation Continued
VERIFICATION
B. Relay #2: Start Relay Continued
d. Start Relay with Standard/Basic Auto Reverse Panel
i. Wire relay using NO contacts across the Start Button (use the middle set of contacts).
ii. Wire relay using NO contacts from the Start Relay to red wire on Start Button.
iii. Connect the common contact from the Start Relay to the black wire on Start Button.
e. Start Relay with Standard/Basic Panel
i. Wire relay using NO contacts.
ii. Wire relay using NO contacts from the Start Relay to light blue wire on the Safety
Relay.
iii. Connect the common contact from the Start Relay to the grey wire on Safety Relay.
4. Complete any other optional hardware installation as required.
NOTE Verification in one of the two following ways will ensure proper operation of the control functions.
1. Use the website (user interface) to start and stop the system and verify the ontracbyreinke.com
system started and stopped with the commands and skip to step 6, or use step 2-6.
2. Use the push buttons to the left of the LCD to interact with the LCD.
3.
Navigate to the Control Output Menu, Output 1, Output On/Off: Set to On, press Enter then Escape
OR
to the home screen. This will activate the relay on output 1 to stop the system.
4.
Navigate to the Control Output Menu, Output 2, Output On/Off: Set to On, press Enter then Escape
to the home screen. This will activate the relay on output 2 to start the system.
5.
Verify Output 1 stops the system and Output 2 starts the system.
6.
Verification is complete. Complete the verification process for each option installed.
Next: Navigation through menus and
move to next digit when entering
number sequence manually
Back: Scroll
through a menu
and change digit
displaced by
entering numbers
manually
Reset: Re-boots the
board
Enter: Press
twice to Enter
Main Menu
Escape: Allows user to back out of any menu or
submenu