R&S FSMR, Operating Manual

Page: 748 / 955

SYSTem Subsystem R&S FSMR
1313.9723.12 6.1-212 E-1
COMMAND PARAMETERS UNIT COMMENT
SYSTem
:IDENtify
:FACTory
query only
:IFGain
:MODE
NORMal | PULSe
:LANGuage <string> no query
:MSIZe? MBOard | B100 query only
:PASSword
[:CENable]
<string> no query
:PRESet no query
:RSWeep <Boolean>
:SET no query
:SPEaker
:VOLume
0 to 1
:TIME <numeric_value>
:VERSion? query only
SYSTem:COMMunicate:GPIB:RDEVice:COMMand 0..30,<command string>
This command sends a command or query string to the device using the GPIB interface FSP-B10.
Usually an external generator is connected to this interface.
Only basic I/O is possible with this device. The first parameter is the GPIB address of the device
connected with GPIB interface of option FSP-B10.
Example:
":SYST:COMM:GPIB:RDEF:COMM 18, ’*RST’"
' generator reset; gen. frequency 2 GHz
":SYST:COMM:GPIB:RDEF:COMM 18, ’SOURCE:FREQ:CW 2E9’ "
' gen. power 0dBm
":SYST:COMM:GPIB:RDEF:COMM 18, ’SOUR:POW 0’"
":SYST:COMM:GPIB:RDEF:COMM? 18, ’SENS:POW?’ "
‘queries the generator power
Characteristics: *RST value: -
SCPI: device-specific
SYSTem:COMMunicate:GPIB:RDEVice:GENerator<1|2>:ADDRess 0 to 30
This command changes the IEC/IEEE-bus address of the device selected as external generator 1 or 2.
If two generators are connected at the same time to IECBUS 2 their addresses must be
different.
Example:
"SYST:COMM:GPIB:RDEV:GEN1:ADDR 19" '
Changes the IECBUS address
'of generator 1 to 19
Characteristics: *RST value: 28
SCPI: device-specific