R&S FSMR, Operating Manual

Page: 523 / 955

R&S FSMR Status Reporting System
1166.3363.12 5.25 E-1
STATus:QUEStionable Register
This register comprises information about indefinite states which may occur if the unit is operated
without meeting the specifications. It can be queried by commands
STATus:QUEStionable:
CONDition?
and
STATus:QUEStionable[:EVENt]?
.
Table 5-6 Meaning of bits in STATus:QUEStionable register
Bit No. Meaning
0 to 2 These bits are not used
3
POWer
This bit is set if a questionable power occurs (cf. also section "STATus:QUEStionable:POWer Register")
4
TEMPerature
This bit is set if a questionable temperature occurs.
5
FREQuency
The bit is set if a frequency is questionable (cf. section "STATus:QUEStionable:FREQuency Register")
6 to 7 These bits are not used
8
CALibration
The bit is set if a measurement is performed uncalibrated (=^ label "UNCAL")
9
LIMit (device-specific)
This bit is set if a limit value is violated (see also section STATus:QUEStionable:LIMit Register)
10
LMARgin (device-specific)
This bit is set if a margin is violated (see also section STATus:QUEStionable:LMARgin Register)
11
SYNC (device-dependent)
This bit is set if, in measurements or premeasurements in GSM MS mode, synchronization to midamble fails or
no burst is found.
This bit is also set if, in premeasurements in GSM MS mode, the result differs too strongly from the expected
value (see also "STATus:QUEStionable:SYNC Register").
12
ACPLimit (device-specific)
This bit is set if a limit for the adjacent channel power measurement is violated (see also section
"STATus:QUEStionable:ACPLimit Register")
13 to 14 These bits are not used
15 This bit is always 0.