R&S FSMR, Operating Manual

Page: 718 / 955

SENSe:PMETer Subsystem R&S FSMR
1313.9723.12 6.1-182 E-1
[SENSe<1|2>:]PMETer:MTIMe SHORt | NORMal | LONG
This command determines the measurement time of the power sensor.
The
SHORT setting is recommended because it provides the highest measurement repetition rates.
The NORMAL setting increases the stability of the displayed results for the measurement of signals
with low power or of modulated signals.
The
LONG setting is recommended for signals at the lower end of the measurement range (<-
20 dBm). This setting can be used to minimize the influence of noise.
Example:
"PMET:MTIM SHOR"
‘ selects the short time for the measurement of
stationary signals with high power
Properties: *RST value: NORM
SCPI: device-specific
[SENSe<1|2>:]PMETer:MTIMe:AVERage:COUNt <numeric_value>
This command defines the number of averages for the manual average mode of the power meter.
Example:
"PMET:MTIM:AVER:COUN 8"
Characteristics: *RST value: ?
SCPI: device dependent
[SENSe<1|2>:]PMETer:MTIMe:AVERage[:STATe] ON | OFF
This command activates/deactivates the auto average mode of the power meter.
Example:
"PMET:MTIM:AVER ON"
Characteristics: *RST value: ON
SCPI: device dependent
[SENSe<1|2>:]<1|2>:]PMETer:[:STATe] ON | OFF
This command switches measurements with an external power sensor on or off.
Example:
"PMET:EXT ON"
‘ witches measurements with an external power sensor
on
Properties: *RST value: OFF
SCPI: device-specific