R&S FSMR, Operating Manual, Page: 42 / 955

Getting Started with the Instrument R&S FSMR
1166.3363.12 1.16 E-2
Getting Started with the Instrument
The following section describes how to activate the instrument and how to connect external devices
such as printer and monitor.
Chapter 2 explains the operation of the instrument using simple measurement examples.
Important:
Prior to switching on the instrument, make sure that the following conditions are fulfilled:
•
The instrument cover is in place and tightly screwed on
•
Fan openings are not obstructed
•
Signal levels at the inputs are within specified limits
•
Signal outputs are connected correctly and not overloaded .
Any non-compliance may cause damage to the instrument .
Preparing the Instrument for Operation
remove protective caps
Take the instrument out of the packaging and check whether the
items listed in the packing list and in the lists of accessories are all
included.
Remove the two protective covers from the front and rear of the
R&S FSMR and carefully check the instrument for damage.
Should the instrument be damaged, immediately notify the carrier
and keep the box and packing material.
For further transport or shipment of the R&S FSMR, the original
packing should be used. It is recommended to keep at least the two
protective covers of the front and rear panels in order to prevent
damage to the controls and connectors.
Setting Up the Instrument
Standalone Operation
The instrument is designed for use under general laboratory conditions. The ambient conditions required
at the site of operation are as follows:
Wrist strap with cord
Building ground
Floor mat
Ground connection
of operational site
Heel strap
•
The ambient temperature must be in the range specified in
the data sheet.
•
All fan openings must be unobstructed and the air flow at
the rear panel and at the side-panel perforations must be
unimpeded. The distance to the wall should be at least
10 cm.
•
The mounting surface should be flat.
•
To avoid damage of electronic components of the DUT
due to electrostatic discharge on manual touch, protective
measures against electrostatic discharge are
recommended.