R&S FSMR, Operating Manual, Page: 384 / 955

Recalling Data Sets R&S FSMR
1313.9617.12 4.20-8 E-1
The EDIT FILE NAME softkey sets the focus on the File Name field and.
In the Save dialog box, the field already contains a suggestion for a new name: the
file name used in the last saving process is counted up to the next unused name.
For example, if the name last used was "test_004", the new name "test_005" is
suggested, but only if this name is not in use. If the name "test_005" is already in
use, the next free name is suggested, e.g. "test_006". You can change the
suggested name to any name conform to the following naming conventions.
The name of a settings file consists of a base name followed by an underscore and
three numbers, e.g. "limit_lines_005". In the example, the base name is
"limit_lines".
The base name can contain characters, numbers and underscores. The file
extension is added automatically and can not be changed.
The
EDIT COMMENT softkey activates the entry of commentary concerning the
current data set. The focus is set on the Comment field and an on-screen
keyboard opens.
SELECT
ITEMS
The SELECT ITEMS softkey moves the selection bar to the first line, left column of
the Items field. An entry is selected. Position the entry focus to the corresponding
partial data set using the cursor keys and then press the ENTER key in the desired
line. The selection is cleared by pressing the key again.
IEC/IEEE command:
Current Settings:
MMEM:SEL:HWS ON
All Limit Lines:
MMEM:SEL:LIN:ALL ON
All Traces:
MMEM:SEL:TRAC ON
Source Cal Data:
MMEM:SEL:SCD ON
Note that the command MMEM:SEL:SCD ON (Source Cal Data) is only
availablewith option R&S FSU-B09 or R&S FSU-B10.
The Dialog
Save table offers the following selectable data subsets in the Items field:
Current Settings These settings include:
•
current configuration of general instrument parameters
•
current measurement hardware settings
•
active limit lines:
A data set may contain maximum 8 limit lines for each window.
It always contain the activated limit lines and the de-activated
limit lines used last, if any.
Consequently, the combination of the restored de-activated limit
lines depends on the sequence of use with command
MMEM:LOAD
.
•
the activated transducer factor
•
user-defined colour settings
•
configuration for hardcopy output
•
settings of tracking generator (only with option tracking
generator)
•
settings of tracking generator (only with option)
All Limit Lines all limit lines
All Transducer all transducer factors
All Traces all traces which are not blanked
Source Cal Data correction data for tracking generator (only with options B9 / B10)