R&S FSMR, Operating Manual, Page: 575 / 955

R&S FSMR CALCulate:MARKer Subsystem
1313.9723.12 6.1-39 E-1
CALCulate<1|2>:LIMit<1 to 8>:UPPer:STATe ON | OFF
This command switches on or off the indicated limit line in the selected measurement window. The
limit check is activated separately with
CALC:LIM:STAT ON.
Example: "
CALC1:LIM4:UPP:STAT ON"
'Switches on limit line 4 (upper limit) in
'screen A.
"
CALC2:LIM4:UPP:STAT ON"
'Switches on limit line 4 (upper limit) in
'screen B.
Characteristics: *RST value: OFF
SCPI: conforming
CALCulate<1|2>:LIMit<1 to 8>:UPPer:THReshold <numeric_value>
This command defines an absolute threshold value for limit lines with relative Y axis scaling
independently of the measurement window. The absolute threshold value is used in the limit check
as soon as it exceeds the relative limit value.
The unit must correspond to the unit selected with
CALC:LIM:UNIT
(except dB which is not
possible). If no unit is indicated, the unit defined with
CALC:LIM:UNIT
is automatically used
(exception: dBm instead of dB).
The units DEG, RAD, S, HZ, PCT are not available in the SPECTRUM mode.
Example: "
CALC:LIM2:UPP:THR -35DBM"
'Defines an absolute threshold value
'for limit line 2.
Characteristics: *RST value: -200 dBm
SCPI: device-specific