R&S FSMR, Operating Manual

Page: 504 / 955

Starting Remote Control Operation R&S FSMR
1166.3363.12 5.6 E-1
Remote Control in a Network (RSIB Interface)
Setting the Device Address
For control of the instrument in a network, it must be accessed using the preselected IP address.
The IP address of the instrument (device address) is defined in the network configuration.
Setting the IP address:
¾ Call SETUP - GENERAL SETUP – CONFIGURE NETWORK menu.
¾ Select "Protocols" tab.
¾ Set IP address for TCP/IP protocol under "Properties" (see section on option R&S FSMR-B16).
Return to Manual Operation
Return to manual operation can be made manually via the front panel or remotely via the RSIB
interface.
Manually: ¾ Press LOCAL softkey or PRESET key.
Note:
– Make sure that the execution of commands is completed prior to switchover
since otherwise the instrument will switch back to remote control
immediately.
Via RSIB interface: ...
CALL RSDLLibloc(analyzer%, ibsta%, iberr%, ibcntl&)
'Set
device to manual control
...