SECTION 18: BODY
DOB 2490-2789 | X3-45 Commuter PA1605 Maintenance Manual (Final Version – Rev.2 April 2016)
67
18.1
Front Steps Replacement Procedure
MATERIAL
Part No
Description
Qty
682989 Anti-silicone
A/R
683097
Sika 205 (1 liter)
A/R
685101
Sika Remover 208
A/R
683916
Sika 215 (1 liter)
A/R
1. Cut and remove damaged step(s).
2. Remove dirt and adhesive residue.
NOTE
In wintertime, condensation and cold temperature may greatly influence bonding parameters. Working
area must be at a temperature sufficient to prevent reaching condensation point. Mechanically preheat
working area (heat lamp or heat gun) or wait until vehicle reaches room temperature.
PREPARATION OF “TARABUS” FLOOR COVERING
1. Sand under step using “Scotchbrite”.
2. Clean using anti-silicone (refer to Section A).
Section A Alcohol or Anti-silicone
1.
Apply
2.
Dry immediately
3.
Allow drying
Mandatory
Minimum time : Wait for product to evaporate
After 2 hours: Start cleaning operation again
Before applying any other
product
If surface seems dusty, greasy or with finger marks, start cleaning
operation again.
3. Apply Sika Primer 215 (refer to Section D).
CHIX cloth
Blue cloth
