SECTION 06: ELECTRICAL
DOB 2490-2789 | X3-45 Commuter PA1605 Maintenance Manual (Final Version) – Sec 06 revised June 2017
45
replaced as an assembly. Turn signal is visible
from both front and side.
Removal and replacement
1. Pull the release handle located inside the
front service compartment to tilt down the
entire bumper assembly.
2. Remove the headlight screw fixing the
headlight assembly, then tilt headlight
assembly down (Figure 41).
3. Partially unfasten back plate fixing screws,
then remove signal lamp.
4. Remove socket from signal lamp.
5. Install wiring connector on back of new
signal lamp then install signal lamp.
6. Fasten back plate fixing screws then tilt
headlight assembly up into its housing then
secure using fixing screw.
Note
Make sure headlight assembly is properly
positioned into its housing before securing
using fixing screw.
10.1.5 Stop, tail, directional, back-up, and
hazard warning lights
A combination stoplight, taillight, directional
signal light and back-up light assembly is
mounted at the rear, on each side of the vehicle.
Furthermore, when braking, two center
stoplights (led) and a center high-mounted stop
light (chsl) (led) will illuminate simultaneously
with the stoplights on the sides for increased
safety. The L.H. and R.H. side center stop lights
are also used as directional signal and marker
lights.
The stop, tail, directional signal and back-up
lights consist of individual lamps, each equipped
with 6 led lights, mounted on the engine rear
door.
Led lights are not replaceable and each lamp is
serviced individually as a complete unit.
The hazard warning flashing system uses the
front, side and rear directional lights
simultaneously. This system is energized by a
switch on the L.H. dashboard.
FIGURE 47: REAR TAIL LAMPS
10.1.6 Lamp Removal And Replacement
1. Open engine compartment rear door.
2. Remove the lamp pod from the engine
compartment door by unscrewing the Torx
hold down screws (4) at the back of the door
and the two (2) side retaining nuts.
3. Remove the lamp support retaining screws
(2), and then from the outside, disconnect
and remove the faulty lamp and its support.
4. From the outside, install the new lamp with
its support then fasten the retaining screws.
5. Reinstall the lamp pod on the door and
reconnect the lamp..
