SECTION 18: BODY
DOB 2490-2789 | X3-45 Commuter PA1605 Maintenance Manual (Final Version – Rev.2 April 2016)
47
15.5.3 EVAPORATOR COMPARTMENT DOOR
FIGURE 44: EVAPORATOR DOOR (ALUMINUM)
For the adjustment of an evaporator door, you
will need:
Centering tool G34148_500
Door adjustment
1. Open the evaporator door.
2. Loosen the screws fixing the hinge to
hinge attachment or hinge to door as-
sembly. Loosening the screws allows
the evaporator door assembly to be
shifted "LEFT or RIGHT" and "UP or
DOWN" or “IN and OUT”.
3. Adjust evaporator door assembly posi-
tion at the hinge.
4. Door exterior panel on hinge side should
be positioned at 29mm +/- 2mm meas-
ured from bus frame out.
5. Respect the required gap between exterior
finishing panels.
6. Tighten the hinge screws.
7. To allow adjustment of the latch mechanism,
lightly tighten the retaining hardware on
receptacle and receptacle support to frame.
8. Place centering tool G34148_500 in the
receptacle cavity.
9. Close door to center the latch assembly.
10. Tighten the Receptacle screws only.
