SECTION 06: ELECTRICAL
46
DOB 2490-2789 | X3-45 Commuter PA1605 Maintenance Manual (Final Version) – Sec 06 revised June 2017
FIGURE 48: TAILLAMP POD RETAINING SCREWS &
NUTS
10.1.7 Center Stoplights And Center High-
Mounted Stop Light (Chsl) Removal And
Replacement
These (led) lights are sealed unit and should be
replaced as an assembly in accordance with the
following procedure:
1. Unscrew both “Phillips” light screws then
remove the light assembly.
2. Install new light assembly and secure using
screws.
10.1.8 License plate light
Two led units are mounted above the rear
license plate(s) of vehicle. In case of burn out,
the led unit must be changed according to the
following procedure.
1. Pry out the rubber seal with a small
screwdriver. Pull on the led unit and
disconnect it.
2. Reconnect new led unit, place rubber seal,
and press on it until it is seated in position.
10.1.9 Clearance, identification and marker
lights
The vehicle is equipped with marker,
identification and clearance lights (led). The
clearance lights are mounted at each corner of
the coach near the top and the identification
lights are in the upper center of rear and front
sections.
The rear clearance and identification lights are
red and the front ones are amber.
The amber marker lights are mounted along the
sides of vehicle.
The side marker light is a sealed unit (led) and
should be replaced as an assembly in
accordance with the following procedure:
1. Unscrew both
“phillips”
light screws, and
then remove the light assembly.
2. Position the new light assembly and install
the “phillips” screws.
10.1.10
Clearance and identification light
removal and replacement
The clearance and identification light are sealed
units (led) and can be replaced in accordance
with the following procedure:
1. Unscrew both “phillips” light screws, and
then remove the light assembly.
2. Position the new light assembly, and then
install the “phillips” screws.
11.
INTERIOR LIGHTING EQUIPMENT
11.1 CONTROL PANEL LIGHTING
The instrument gauges and switches mounted
on all control panels are energized whenever the
exterior light switch is pushed to the first
position. A control dimmer located on the
dashboard is used to vary the brightness of the
panel gauges, switches and indicator lights.
The gauge lights, panel lights, switch lights and
indicator lights have a different bulb
arrangement. Thus, the procedure to change a
defective bulb can vary according to the
application.
11.1.1 Switch lighting
1. Slightly pull the switch with a defective led
away from the control panel.
