Planmeca Proline CC, Technical Manual

Page: 33 / 207

Chapter C - HELP & ERROR MESSAGES
Planmeca Proline CC panoramic x-ray C-3
Technical Manual
E r 4 2
Secondary slot not in the position for the panoramic exposure.
E r 4 3 Secondary slot not in the position for the cephalometric exposure.
E r 4 4
The patient positioning mechanism zero point set incorrectly.
E r 4 5 The soft tissue filter position not calibrated.
E r 5 0
The temperature of the tube head is too low.
E r 5 1 Temperature sensor open.
E r 5 2
mA or kV feedback cable open.
E r 5 3 Up/down motor does not consume power.
E r 5 4
Up/down motor consumes too much power.
E r 5 7 Exposure button activated when the unit is turned on.
E r 6 0
Generator processor power too low.
E r 6 1 Processor communication error.
E r 6 2
Limit sensor power missing.
E r 6 4 The radiation reaching the AEC sensor is very low or missing completely.
E r 6 5
The radiation reaching the AEC sensor is too high.
E r 7 0 Processor communication error.
E r 7 1
Generator processor program memory failure.
E r 7 2 Keyboard processor program memory failure.
E r 7 3
Keyboard processor program error.
E r 7 4 Keyboard processor operating improperly.
E r 7 5
Keyboard processor operating improperly.
E r 8 0 Keyboard processor EEPROM failure.
E r 8 1
Generator processor EEPROM failure.
E r 8 2 Keyboard processor configuration error.
E r 8 3
Generator processor configuration error.
E r 8 4 Tube power generator time out.
E r 9 0
Keyboard processor EEPROM not activated.
E r 9 1 Keyboard processor stack overflow.
E r 9 9
Error code generation error.
ERROR CODE ERROR MESSAGE EXPLANATION