7. In OP deliveries, attach the long end of the sterile water tube to the OP
delivery arm with the clips included in the sterile water tube package.
8. Enable sterile water from the instrument spray settings. See section
"Enabling/disabling sterile water mode" on page 182.
10.6.3 Extending sterile water tube
If the sterile water tube is too short, you can extend it with one or two
extension tubes, depending on how long a sterile water tube you need.
The following instructs how to join two extension tubes with the sterile water
tube before routing the tube from the instrument to the sterile water bag, but
note that you may well use only one extension tube, provided it gives you
the required length. You may also cut the extension tube shorter, if needed.
1. Cut the sterile water tube at location marked with (1) in picture.
2. Attach the two extension tubes to each other with a tube joint (provided
with extension tube pack) (2). This creates the joint extension tube.
3. Attach one end of the joint extension tube to the sterile water tube with
nozzle (3).
4. Attach the other end of the joint extension tube to the sterile water tube
with pump part (4).
5. This part (5) goes into the sterile water bag.
6. This part (6) goes into the pump.
10 Instrument system
54 Planmeca Compact i
User's manual
Summary of Contents for Compact i5
Page 1: ...PlanmecaCompact i5 user s manual EN 30011782...
Page 10: ...Table of contents Planmeca Compact i User s manual...
Page 325: ......
