Panasonic LX-TD500, Programming Manual

Page: 26 / 388

Configuration
26 Programming Guide
Parameter First Dial Timer (DID / TIE)
Default 64 ms
Value Range 32-8160 ms in 32 ms increments
Description/Function On outgoing DID / TIE line calls, the system waits at least 64
milliseconds after seizing the trunk line, before sending the dialing
digits to the Central Office / other PBX by default. This allows the
Central Office / other PBX enough time to accept the dialing digits
correctly.
Specifies the appropriate value depending on the requirements of
your local Central Office.
Reference • 1.3 System Features (F/G)
– T1 Carrier
• 1.5 Attended Features (F/G)
– Direct Inward Dialing (DID)
• 3.1 TIE Line Features (F/G)
• 4.2
Trunk Line (P/G)
– Start Signal Type
Parameter % Break
Default 60%
Value Range 1.
60%
2.
67%
Description/Function Specifies the % break for pulse digits.
This is the ratio between on-hook and off-hook signals during digit
transmission.
Reference • 1.3 System Features (F/G)
– T1 Carrier
Parameter Pulse Feedback Tone
Default Yes
Value Range 1.
Yes
2.
No
Description/Function On outgoing CO calls, the dialed number is toned out, which
informs the extension users that dialed number has been dialed out.
The dialed number is toned out by default. Select "No" to turn off
the pulse feedback tone.
Reference • 1.3 System Features (F/G)
– T1 Carrier