![background image](http://html.mh-extra.com/html/omron/nt11s/nt11s_operation-manual_744536072.webp)
-- -- -- -- -- Help Message -- -- -- -- --
Data successfuly transmitted
(Hit any key to continue)
56
Registering the Screen Data
Section 3-6
6.
When the screen data transmission is completed, the support tool will display
the following screen.
7.
Press any key on the support tool to return to the File Selection screen.
8.
You can quit the Transmit Mode and return to the RUN mode by simultaneous-
ly pressing any two of the four function keys on the panel of the NT11S. The
same result is achieved when the NT11S receives a transfer end instruction
from the support tool.
Precautions to be Observed During the Screen Data Transmission
When any of the following or a system error occurs during the screen data trans-
mission, the transmitted screen data will not be registered correctly to the NT11S.
If an error message is displayed in the System Menu and the Transmit Mode can-
not be selected, the screen data memory needs to be initialized.
S
The power to the NT11S is interrupted or the NT11S is reset.
S
The power to the computer on which the support tool is running is interrupted or
thr computer is reset.
S
The cable connecting the NT11S to the computer on which the support tool is
running is disconnected or has a broken wire.
S
Screen data transfer is terminated by pressing any two of the function keys on
the panel of the NT11S.
S
The ESC key on the support tool is pressed to end the transmission.
When the power to the NT11S is turned ON or reset, the screen data is checked.
However, if any of the above occurs during the screen data transmission, the
screen may disappear and other unexpected problems may occur.
In the case of such problems, set DIP-SW2-2 to ON to initialize the memory.
For the memory initialization by using the DIP switch, refer to the “Initialization by
using the DIP switch” (page 50).
Summary of Contents for NT11S
