![background image](http://html.mh-extra.com/html/omron/nt11s/nt11s_operation-manual_744536069.webp)
Erase system program
Are you sure?
(Yes:F3+F4, No:ENT)
Erasing...
Erasing is completed
Set DIP-SW2-6 to off
and press reset-SW
53
Registering the Screen Data
Section 3-6
S
Transfer is terminated by pressing the ESC key of the personal computer run-
ning the system transfer tool.
In the event of any of the above, there is a possibility that the NT11S will not oper-
ate or that unpredictable malfunctions will occur.
To prevent this, switch DIP switch SW2-6 ON to erase the system program after
the problem has occurred. For details on erasing the system program with the DIP
switch, refer to “Method for Erasing the System Program” (page 53).
Method for Erasing the System Program
In order to erase the system program, the system program area must be cleared.
On shipment there is no data in the system program area and therefore the system
program can be transferred without having to erase an existing system program
first; however, if a system program already exists it must be erased before the new
one can be transferred.
The following is the procedure for erasing the system program.
Operation 1.
Set DIP SW2-6 to the ON position and turn on the power or reset: the following
screen will be displayed.
2.
Press the “return” key if you want to quit without erasing the program. If you do
want to erase the program, press any two of the function keys simultaneously:
this will start erasure of the program.
During erasure, the screen shown below is displayed:
3.
On completion of erasure, the screen shown below is displayed. At this point
set DIP SW2-6 to the OFF position and reset the NT11S.
Summary of Contents for NT11S
