![background image](http://html.mh-extra.com/html/omron/nt11s/nt11s_operation-manual_744536043.webp)
Caution
27
Connection to a PC by the Host Link (RS-232C Type)
Section 2-4
2-4-2
Connecting the NT11S
Refer to the illustrations below to select the appropriate cable for the unit connec-
tors and connect the NT11S to the PC.
To make a connector cable, refer to Appendix D Method for Making the Cable for
Connection to the PC (page 146).
S
Before inserting or removing the connectors, make sure that the NT11S and the
PC are turned OFF.
S
After connecting a communication cable, always secure it with the screws.
Otherwise the cable may disconnect, causing operation to fail.
S
The cable’s tensile load is 30 N. Do not subject it to loads greater than this.
Otherwise a discontinuity may occur, causing operation to fail.
Connecting to a PC with a 25-pin Connector
Use a connector cable with a 25-pin connector on one end and a 9-pin connector
on the other end (NT11S side) to connect the NT11S to a PC with a 25-pin connec-
tor.
Host I/F connector
(RS-232C 9-pin type)
C200H,
C200HS
Host link unit/CPU unit
9-pin connector
25-pin connector
RS-232C connector cable
NT11S
Connecting to a PC with a 9-pin Connector
Use a connector cable with a 9-pin connector on both ends to connect the NT11S
to a PC with a 9-pin connector.
Host I/F connector
(RS-232C 9-pin type)
C200H,
C200HS
Host link unit/CPU unit
9-pin connector
RS-232C connector cable
9-pin connector
NT11S
Summary of Contents for NT11S
