![background image](http://html.mh-extra.com/html/omron/nt11s/nt11s_operation-manual_744536076.webp)
SYSTEM MENU
Quit
Transmit Mode
Maintenance Mode
PT Setting
I/O Check
Initialize Memory
Memory Switch
Backlight OFF
10min
Page:
Auto-restart
Yes
60
Setting the Conditions of Communications with the PC by Using the Memory Switches
Section 3-7
3-7-3
Selecting the Automatic Reset Function
The “Auto-restart” memory switch is used to set whether or not the communication
is automatically reset after the occurrence of a communication error.
The factory setting has been made at “OFF”.
Select the Automatic Reset Function of the communication with the PC by the
menu operation from the System Menu as mentioned below.
Select “Maintenance Mode”
with the
key, then press “EN-
TER”.
Select “Memory Switch” with the
key, then press “ENTER”.
Select “Auto-restart” with the
key.
Pressing the [+/--] key while “Au-
tomatic Reset” is highlighted will
cause the selection for this item
to alternate between “No” and
“Yes”.
To quit after setting the selection made, press the “ENTER” key. To quit without
setting the selection made, press any two function keys simultaneously.
S
“OFF”: If a communication error has occurred, corresponding error message is
displayed and the operation stops.
S
“ON”: If a communication error has occurred, corresponding error message will
not be displayed and the operation will be automatically reset.
Summary of Contents for NT11S
