Omron NT11S, Operation Manual

Page: 36 / 183

20
Description of Parts and Settings
Section 2-1
2-1-2 DIP Switch Settings
Set the NT11S operation status with the DIP switches located in the bottom right
corner on the rear side of the body.
Switch # Function
SW2-1 RS-422A terminal resistor connection SW2-1
ON Terminal resistor used
[OFF] Terminal resistor not used
SW2-2 Screen data forced initialize effective/ineffective SW2-2
ON The NT11S will start in a special RUN mode in which the screen
data memory is initialized. When it is started, the memory initial-
ization menu will be displayed. For the initialization procedure,
refer to Section 3-4 Initializing Memory (page 48).
[OFF] The NT11S will start in normal RUN mode.
SW2-3 Screen display language mode SW2-3
ON
[OFF]
Messages are displayed in English.
SW2-4 Switching to the System Menu enabled/disabled SW2-4
ON The System Menu cannot be displayed. If an error occurs during
a start-up, the System Menu will be automatically displayed.
However, “RUN Mode” cannot be entered.
[OFF] The System Menu can be displayed.
SW2-5 Not used.
SW2-6 System program erase SW2-6
ON The menu for deleting the system program is displayed on strat-up.
[OFF] Start-up proceeds as normal.
[ ] indicates factory setting.