![background image](http://html.mh-extra.com/html/omron/nt11s/nt11s_operation-manual_744536062.webp)
Note
46
Operation Modes and the System Menu
Section 3-3
3-3-3
Operations with the System Menu
The following gives the procedure to call the System Menu, select the menu items,
and other operations with the System Menu.
Make sure that DIP SW2-4 “Switching to the System Menu enabled/disabled” is
set to OFF (enabled). If the setting is ON (disabled), the System Menu will not be
displayed by following the procedure given below.
Displaying the System Menu
The system menu can be displayed by switching on the power while any two of the
four function keys are held down.
SYSTEM MENU
Quit
Transmit Mode
Maintenance Mode
Hold down any
two of the four
function keys.
Basic key operations in the maintenance mode
Operation
Function
Any two function keys
Cancel
[ENTER] key
Set/execute
Arrow keys
Cursor motion
Note that on the screen for confirming erasure of the system program, the “Can-
cel” and “Set/execute” keys are displayed in reverse video in order to prevent mis-
taken deletion of the program.
Selecting the Menu Items
Press the
or
key on the panel of the NT11S to move the highlighting up or
down. When the required item is highlighted, press the “ENTER” key to select it.
Menu items allow to make the ON/OFF selection or to call subsequent menu or
screen.
Example 1
To call the “Maintenance Mode Menu” by selecting the “Maintenance Mode” on the
System Menu screen:
Summary of Contents for NT11S
