![background image](http://html.mh-extra.com/html/omron/nt11s/nt11s_operation-manual_744536053.webp)
Caution
37
Connection to a PC by the NT Link
Section 2-6
2-6
Connection to a PC by the NT Link
Connect the NT 11S to an OMRON PC by the NT link method.
To connect the NT11S to a PC by the NT link method, the NT11S memory switch
for “host communication” must be set for the NT link. For the “host communication”
setting, refer to “Selecting the Host Communication Method” (page 58)
2-6-1
Compatible PCs
Some models and series of OMRON PCs have the host link function built in.
Check the model and series of the PC against the type of host link unit before
marking the connections.
The compatible PCs are listed in the table below.
PC Series
CPU Unit
Connectable to
C series
CQM1-CPU41-E
CQM1-CPU42-E
CQM1-CPU43-E
CQM1-CPU44-E
CQM1
C series
C200HS-CPU21-E
C200HS-CPU23-E
C200HS-CPU31-E
C200HS-CPU33-E
C200HS
2-6-2
Connecting the NT11S
Refer to the illustrations below to select the appropriate cable for the unit connec-
tors and connect the NT11S to the PC.
To make a connector cable, refer to Appendix D Method for Making the Cable for
Connection to the PC (page 146).
S
After connecting a communication cable, always secure it with the screws.
Otherwise the cable may disconnect, causing operation to fail.
S
The cable’s tensile load is 30 N. Do not subject it to loads greater than this.
Otherwise a discontinuity may occur, causing operation to fail.
Use a connector cable with a 9-pin connector on both ends to connect the NT11S
to a PC with a 9-pin connector.
CPU unit
C200HS,
CQM1
9-pin connector
RS-232C connector cable
9-pin connector
NT11S
Host I/F connector
(RS-232C 9-pin type)
Summary of Contents for NT11S
