Nustep TRS 4000, Service Manual

Page: 76 / 130

TRS 4000
support@nustep.com - (800) 322-4434 - (734) 769-3939 x 5
support@nustep.com - (800) 322-4434
Wheel & Axle
Tools Required Parts Required
2 blocks of wood 3/8" pushnut(s)
Channel lock pliers
Rubber hammer
Safety glasses
1. Prop rear of NuStep on block of
wood and remove pushnut with
pliers. 2. Remove wheel(s) and/or axle.
Pushnut will be destroyed during re-
moval.
3. To install, place wheels and axle back on and balance pushnut onto end
of axle. Hold block of wood gently against pushnut on opposite side. With
one direct hit, hit pushnut on. Continue to hit pushnut on until there are
slight gaps between pushnuts and wheels on both ends.
Do not hit pushnut on too tight as damage
may occur and/or wheels may not roll.
42109 Wheel and Axle Removal 5-01-05
68
The TRS 4000 is very heavy; it weighs 205 lbs (93 kg). To avoid injury, or damage to
the product, always obtain assistance to move this product. Use proper lifting
technique.
!
CAUTION
To avoid injury, wear safety glasses.
!
CAUTION