Nustep TRS 4000, Service Manual

Page: 39 / 130

TRS 4000
support@nustep.com - (800) 322-4434 - (734) 769-3939 x 5
support@nustep.com - (800) 322-4434
Magnet – EC & Pivot Disks
NOTE: This magnet is located on both the EC & Pivot Disks and activates the VR & Hall
Effect Sensors. If the magnet was installed correctly, it will not come off. This
instruction is for the unlikely event that the magnet was incorrectly attached and did
come off. The instruction shows the Pivot Disk but the same steps apply for the EC
Disk.
Tools Required
Loctite 324 adhesive
Loctite 7075 or 7387 Activator
3. Wipe/spray activator into the
indent, and let evaporate 10 seconds
minimum. 4. Place Loctite 324 adhesive onto
the side with the red (or black) dot.
5. Press red dot side of magnet into
indent. The sensors will not work if
red dot is out.
6. Check gap. Gap should be 1/8" –
3/16" from magnet to sensor. Test
display to verify operation.
42059 Magnet - EC and Pivot 5-1-05
31
To avoid injury and prevent adverse
health effects, use Loctite in
accordance with the manufacturer’s
material safety data sheets, including
the use of safety glasses and
impermeable gloves. Material safety
data sheets are available via the
internet at
www.loctite.com or by
calling Henkel Corporation at (800) 562-
8483.
!
CAUTION
1. Remove covers. See Cover
Removal instruction.
2. Locate the round indent on the
left side of the Pivot Disk, or right
side of the EC Disk. If there is
residual glue or pieces of magnet,
clean out as best as possible for a
good mounting surface.