2-26 Mounting the terminal
Figure 2-15: Access hole used when installing the number card
Alerter module
(alerter bezel is on
the other side)
Card
reader
Keypad
PCP
o
F. Completing the installation
1.
Re-install the PCP assembly by reversing the steps in
Removing the PCP assembly to install components.
•
Ensure that the cables are fully seated in their
connectors and excess cable is folded and
tucked away from the edges of the terminal.
•
Before you push the PCP assembly fully into the
brackets, ensure that the rear terminal PCP and
validator PCP cables are threaded under the
PCP assembly. As you fit the assembly into the
brackets, you should hear a click when they fit
into place.
•
If the terminal has a smart card alert,
the cable
from the alerter PCP to the smart card alert
daughter board also has to be routed under the
PCP assembly.
2.
Reconnect the upper terminal block to the lower term i
nal block on the rear terminal PCP. This returns power
to the terminal. Refer to Figure 2-16.
Note:
If the terminal has an IAS module, the power
connects to this module.
NTP: 506-6501-203 Document issue: 00.01 Status: Standard Date: January 1997
Summary of Contents for Millennium multi-pay M1211
