7-70 Installing replaceable parts
8.
Feed the connector and cable of the security switch up
through the hole between the vault and the terminal
chassis. The hole is located in the back, right-hand cor
ner.
9.
Position the security switch and mount underneath the
e-lock. The two holes in the switch mount will match the
two bottom holes of the lock. Refer to Figure 7-58.
Figure 7-58: Switch and mount fit under e-iock housing
10. Insert the two screws under the e-lock that hold the
switch in place.
11. Open the terminal housing and locate where the switch
cable was pushed up through the floor of the rear hous
ing.
a) Thread the cable through the cable clamp located
on the side of the rear housing.
b) Connect the cable connector to the connector on
the rear terminal PCP. Ensure the connector is
properly seated.
NTP: 506-6501-203 Document issue: 00.01 Status: Standard Date: January 1997
Summary of Contents for Millennium multi-pay M1211
