8-2 Cleaning the terminal
• Do not swipe the cleaning card more than twice through
the card reader, as excessive swiping could result in
head damage.
• Discard the card after 100 cleaning operations.
The only way to test the performance of a smart card reader
is to make a call. If the reader will not read a valid smart
card, replace the card reader as described in
Replacing the
card reader
in Chapter 7.
Clearing the card slot
The card slot is designed to allow debris inserted into it to
fall to the bottom of the terminal, out of the way. However,
some debris may become trapped in the slot.
If this occurs:
1.
If possible, remove the debris through the entry slot.
2. Otherwise, open the terminal and remove the debris
from the inside.
For instructions on opening the terminal, see
Accessing the inside of the terminal
in Chapter 7. If
it is necessary to replace the card reader, refer
Removing the card reader,
also in Chapter 7. You will
not be able to do this unless you have maintenance-
level privileges on the craft interface.
Note:
Do not probe the card reader with a screwdriver
or other sharp instrument. If the debris is not easily
moveable, replace the card reader.
NTP: 506-6501-203 Document issue: 00.01 Status: Standard Date: January 1997
Summary of Contents for Millennium multi-pay M1211
