Nortel Millennium multi-pay M1211, Installation, Operation And Maintenance Manual

Page: 39 / 350

1-18 Describing the terminal
Smart card a
caller forgets to remove a smart card from the card
. . reader after hanging up, an audible alarm sounds. The oper­
a s ™ atjng company controls the delay time to start the alarm, the
duration of the alarm, and the cadence of the alarm.
The alarm can be configured to ignore cards with zero value.
Card reader
blocked
alarm
If one or more of the card reader sensors are active when the
set is on-hook or in the hang-up-off-hook state for a specified
period, an alarm is generated and transmitted to the Millen­
nium Manager by the terminal. Service is restricted to coin-
only.
This alarm is not sent if the smart card alert is active.
Language
button
The voice and visual prompts can be heard and displayed in
an alternative language. The language button allows callers
to toggle between the two languages. Refer to Figure 1-7.
Next-call
button
The ♦ button allows callers to place another call without re­
inserting a card, providing the handset has not been
returned on-hook. During call setup and when the craft inter­
face is being run, this button acts as an erase button to
correct dialing mistakes. Refer to Figure 1-7
Volume
control
Two buttons, ▲ and T , allow callers to change the volume
of the handset. Four levels are available. The volume reverts
to the lowest level when the handset is replaced on-hook.
Refer to Figure 1 -7.
Figure 1-7: Locating the special buttons
NTP: 506-6501-203 Document issue: 00.01 Status: Standard Date: January 1997