Nortel Millennium multi-pay M1211, Installation, Operation And Maintenance Manual

Page: 81 / 350

2-24 Mounting the terminal
: igure 2-13: R em oving the clam p plate
VFD
(attached to
clamp plate)
Clamp plate
Top of the front
housing
e) Set the internal instruction card against the display
window, with the instructions facing the exterior of
the terminal. Align the notch in the lower edge of the
card and the hole in the tab at the top of the card are
properly located over their corresponding pins on
the upper bezel.
f) Return the clamp plate to its proper position. Keep
the bend in the cable for the VFD connector (J20).
g) Reassemble the ID bezel: ensure that the coin slot
gasket is fitted properly over the opening, then
replace the two screws inside the front housing
assembly to secure the ID bezel and clamp plate.
2. If the terminal has quick access keys, install the label
card:
a) Push on the round rubber stud between the two
screws securing the quick access keys bezel, indi­
cated in Figure 2-14.
NTP: 506-6501-203 Document issue: 00.01 Status: Standard Date: January 1997