7-66 Installing replaceable parts
4. Reverse Steps 1 to 3 to replace the coin compartment
lock.
5. Replace the security PCP as explained in
Replacing
the security PCP.
6. Reconnect the power, and test to make sure the lock is
positioned so its micro-switch actuator is activated by
locking the coin compartment and deactivated by un
locking it.
7. When complete, reconnect the upper terminal block
onto the rear terminal PCP to reconnect the power and
close and lock the housing assembly. Refer to
Opening
the terminal,
if necessary.
8.
Insert a new coin box into the coin vault.
9.
Replace the vault door and lock the vault, as explained
in
Replacing the vault door or the coin box.
Coin vault lock upgrade
This procedure describes how to install extra lock plates on
the coin vault lock.
To upgrade the lock, you need:
• one lock plate with big screw holes
• one reinforcement plate with smaller screw holes
• two spacers
• two M2.5 Phillips or Pozidriv #1 screws
Upgrading the lock
1.
If the terminal has a lock installed, remove the lock, fol
lowing the instructions in
Replacing the coin com part
ment lock,
in the previous section.
2.
Fit the pieces of the lock together as shown in
Figure 7-55 and Figure 7-56 and described below:
a) Place the lock in front of you, with the bolt facing to
your right.
NTP: 506-6501-203 Document issue: 00.01 Status: Standard Date: January 1997
Summary of Contents for Millennium multi-pay M1211
