Installing replaceable parts 7-3
start replacing parts, then re-INSTALL it when you have
completed your tasks.
• If you will be replacing the validator or the escrow, you
do not need to uninstall the terminal, but you do need to
run the INSTALL routine when you are finished.
• If you do not plan to change any of the modules
described in the above two paragraphs, you will not be
required to re-INSTALL the terminal when you complete
your tasks. However, it is recommended that you still
upload the CDRs as a precautionary measure.
Preparing the terminal for maintenance
If you need to enter the terminal to replace parts, or for
further testing, use the following procedure first:
1. Access the maintenance level of the craft interface and
the initial prompt, as explained in
Accessing the initial
maintenance prompt
in Chapter 5.
a) Enter the access code
b) Enter your PIN.
c) Press -*■.
This message
Please use key now
appears
on the VFD:
& open the terminal
2.
Put the key into the key lock on the left side of the hous
ing assembly and turn it clockwise, refer to Figure 7-1.
If it is difficult to turn the key, insert the T- tool or the L-
tool into the hole below the key lock, and apply a slight
force counterclockwise while turning the key clockwise.
3. If you have not already done so, insert the T- tool or L-
tool into the hole below the key lock.
Millennium multi-pay terminal installation, operation, and maintenance guide
Summary of Contents for Millennium multi-pay M1211
