Installing replaceable parts 7-31
8.
Reassemble the components by reversing Steps 1 to 5.
Make sure the locating pin of the window bezel fits into
the location hole in the top center of the clamp plate.
9.
Reinstall the PCP assembly as explained in
Removing
the PCP assembly.
10. When complete, reconnect the power and close and
lock the housing assembly. Refer to
Opening the ter
minal,
if necessary.
R eplacing the external instruction card
The operating company may choose to use external instead
of internal instruction cards. To remove and install an
external instruction card:
1. Make sure the terminal is closed and the card to be re
moved is clean. Press the suction cup firmly on to the
center of the card on the terminal.
2.
Pull on the suction cup until the card bends enough to
pop out of the window.
3. To install the new card, place its lower edge under the
bottom lip of the window opening, and apply pressure to
the outer edges of the card, bending it until it snaps un
der all four edges. Figure 7-22 shows the positioning.
4.
Position the new card so all its outer edges are covered.
Figure 7-22: Installing the external instruction card
Millennium multi-pay terminal installation, operation, and maintenance guide
Summary of Contents for Millennium multi-pay M1211
