Nortel Millennium multi-pay M1211, Installation, Operation And Maintenance Manual

Page: 70 / 350

Mounting the terminal 2-13
5. Look for the serial number of the terminal, found on a
sticker on the rear housing of the terminal. Record this
number to use in the INSTALL terminal-configuration
routine, described later in this chapter.
6. Secure the housing assembly to the backboard using
two pan-head machine screws. The location of the
holes on the inside of the rear housing are shown in Fig­
ure 2-5. Use 1/4-inch no. 20 1/2-inch-long screws.
7. To attach one of the screws, you need to remove the
coin validator. Refer to Figure 2-5.
a) Disconnect the validator cable (J33) from the
control PCP connector (J8). Feed the cable under
the PCP assembly.
— Disconnect the cable to the escrow (J21)
from the escrow connector (PL5).
— Keep the bend in the cable leading to J7;
this ensures the cable will not get pinched
when the front housing is closed.
— Refer to Figure 2-6 to see where the various
components are.
Millennium multi-pay terminal installation, operation, and maintenance guide