Mounting the terminal 2-11
5.
Engage the security studs in the keyhole slots in the
backboard. Then let the terminal slide down into posi
tion.
B. Unlocking and opening the terminal
1.
Put the key in the lock on the upper terminal housing, as
shown in Figure 2-3, and turn the key clockwise.
If it is difficult to turn the key, insert the T- or L-tool into
the hole below the key lock hole and apply a slight force
counterclockwise to relieve the pressure on the key,
while also turning the key clockwise.
2. With the T - or L-tool inserted into the hole below the key
lock, rotate the tool clockwise to release the locking
mechanism.
Figure 2-3: Key and tool needed to open the terminal housing
3.
Remove the handset from its cradle and let it hang by
the armored cord.
4. Grasp the front housing assembly firmly by both sides
and tip it forward until it clears the rear housing.
Allow the front housing to hang downwards, as shown
in Figure 2-4. In the fully opened position, the weight of
the front housing is supported by the link assembly, a
tie-rod which is attached to the front and rear housing.
Millennium multi-pay terminal installation, operation, and maintenance guide
Summary of Contents for Millennium multi-pay M1211
