Mounting the terminal 2-25
Figure 2-14: Rubber stud pushes the quick access keys label
Card reader
Quick access keys bezel
retaining screws
Round rubber stud to push
out quick keys label
i f
window
This will bend the label window outward until the
centre of the window is high enough to grasp. Pull it
out.
b) Insert the card behind the window.
c) Insert one end of the quick access keys label
window in position in the opening in the quick
access keys bezel. Bend the window outward,
insert the opposite end into position and release it.
3. To install the number card on the hookswitch/alerter be
zel, under the handset, proceed as follows:
a) Remove the number card window, if it is installed.
Use a type 1A cross-recess screwdriver of less than
8 mm (5/16 inch) diameter or an equivalent tool to
push on the window from inside the terminal. Refer
to Figure 2-15 to locate the hole, and push until the
number card is free of the alerter bezel.
b) Insert the number card behind the window.
c) Insert one end of the window in position in the
opening of the alerter bezel. Bend the window
outward, insert the opposite end into position, and
release it.
Millennium multi-pay terminal installation, operation, and maintenance guide
Summary of Contents for Millennium multi-pay M1211
