2-14 Mounting the terminal
Note:
If you are unsure of cable connections, look for the
name of the connection printed on the PCP, or refer to
Inter
connections of internal components
in Chapter 1.
Figure 2-6: Coin validator cable connections
Validator
connector
to control PCP
J33/J8
Rear housing
—
(attached to wall)
Coin validator
Rear
terminal
PCP
/ I L i
Validator/escrow
connector
J21/PL5)
Escrow PCP
PCP assembly
Telephony PCP
(left side)
Control PCP
(right side)
i i \ \y.\\ „ w
u r
b) Remove the rubber spacer between the top of the
validator and the top of the rear housing assembly,
if it is present.
c) Remove the plastic retainer strip located between
the reject chute and the housing of the validator, if
it is present. Discard the retainer. The retainer is
required for protection during transportation only.
d) Release the retaining clip securing the validator to
the escrow, indicated in Figure 2-7.
NTP: 506-6501-203 Document issue: 00.01 Status: Standard Date: January 1997
Summary of Contents for Millennium multi-pay M1211
